Post YOUR Hatchback here
User avatar
By egsedanguy
#348354 Installed 1 side last night. Had to do some work around it cause i cut a lil to far :oops: Also the paint was coming up around the cuts from the heat of the cutting disk. Sanded it smooth, a thin coat of glaze coat then feather it all out. Last I put a few coats of primer. After it was finished the light fits in perfect. :woot:
User avatar
By teal_dx
#348357 Nice install on the turn signals :thumb:
User avatar
By egsedanguy
#348434 So this weekend i did the 92 civic ex w/abs front brakes on my hatch. now I have 10.3in rotors in front. all wheel disk brakes. :woot:
old vs new rotors

just to see how it would look

installed and looken great

and fully installed. fills the wheel better and looks much nicer.

User avatar
By egsedanguy
#348516 Well I got board last night so I desided to plasti dip my belt moldings till I get ready to paint then I will Use real paint. looks much better than the shinny chrome.


Then I desided to start shaving my key holes. I have a set of rear door handles that i pulled from my parts car but the damn lef side one is busted. I tried to repair it but it looks like it wont hold. But I did the shave in about 30 min. I have to do a skin coat over the driver side one more time.


I will do more work this weekend so I hope i can get alot done. :thumb:
User avatar
By egsedanguy
#349030 Well I picked up a set of nrg seats. 340$ With sliders and brackets. Also did a limbo comp at my buddy opening of his tattoo shop. Pics now :woot:




My new fav pic


Getting it as low as possible. Got second in hard top. :thumb:
By Cone_Shark
#349317
User avatar
By Civic_HatchSI
#349759 Wow those nrg seats look almost identical to the dc2 Recaros for a fraction of the cost! Nice find