- Sat Aug 10, 2013 2:34 am
#335339
OK guys here is my 5 year long project
Its a 92 dx eg hatch..
built Poor man type r build 81.5 mm 12,5,1 cp ratio
here is the 1st day I got it as a shell
This was my 1st engine swap the good old ls swap
About after 8 months I got tired of the ls
here was the finished product
and just when u think every thing is fine its not the kid that sold mea blown motor then her split never to be seen again
here is the picture after my motor got re built after 8 long months
dyno time
197 hp 145 tq
thanks to speed theory/xenocron
here was my basic build list
dyno tuned by xenocron
hondata s300 ecu
Built GSR ( all Motor 12.5.1)
Acl main,rod,thrust bearing kit
Manley Keepers
Weisco Pistons
Eagel Rods
81.5 mm boar
Block was Decked
Crank was boil $ Micropolished
Ferrea Bronze Valve Guides
Face Valves + 3 angle Valve job
Golden Eagel headstuds
Hondata intake manifold gasket
New oem oil pump
New oem water pump
New thermostat
New Fan switch
New Coolent temp sensor
pappers for every thing about the motor
motor has about 10k on it
i will send pics apon request
skunk2 shift knob
skunk2 shifter
Mint rsx type s seats ( black leather )
GSR motor,B16 trans with ls 5th
every thing went smooth with the motor for about a year and a hafe so it was about time to get rid of the shitty primer for some paint
this is the paint of the new 2013 dodge chargers
Figured it was time to get some rims
Its a 92 dx eg hatch..
built Poor man type r build 81.5 mm 12,5,1 cp ratio
here is the 1st day I got it as a shell
This was my 1st engine swap the good old ls swap
About after 8 months I got tired of the ls
here was the finished product
and just when u think every thing is fine its not the kid that sold mea blown motor then her split never to be seen again
here is the picture after my motor got re built after 8 long months
dyno time
197 hp 145 tq
thanks to speed theory/xenocron
here was my basic build list
dyno tuned by xenocron
hondata s300 ecu
Built GSR ( all Motor 12.5.1)
Acl main,rod,thrust bearing kit
Manley Keepers
Weisco Pistons
Eagel Rods
81.5 mm boar
Block was Decked
Crank was boil $ Micropolished
Ferrea Bronze Valve Guides
Face Valves + 3 angle Valve job
Golden Eagel headstuds
Hondata intake manifold gasket
New oem oil pump
New oem water pump
New thermostat
New Fan switch
New Coolent temp sensor
pappers for every thing about the motor
motor has about 10k on it
i will send pics apon request
skunk2 shift knob
skunk2 shifter
Mint rsx type s seats ( black leather )
GSR motor,B16 trans with ls 5th
every thing went smooth with the motor for about a year and a hafe so it was about time to get rid of the shitty primer for some paint
this is the paint of the new 2013 dodge chargers
Figured it was time to get some rims
