Brandoff's 93 DX coupe 2.0 update page 1

Post YOUR Coupe here
 Reply
User avatar

By FG2_Andrew
- Sat Nov 03, 2012 2:53 am #319104 Image

Image

Hope those help! I can snap a real picture tomorrow if you need!
User avatar

By brandoff88
- Sat Nov 03, 2012 4:24 am #319109 to be honest it really doesnt, i cant really make sense of exploded veiws, but you know what im talking about right? and a real pic would be wonderful :thumb: after i hook that up i can throw on the harness and get my front brakes done and put in the axles... :D :woot:

EDIT: i think it looks like it goes into the thermostat housing? :? im not sure but let me go check real quick and see what i can find and maybe get a pic of where EXACTLY it comes from
Last edited by brandoff88 on Sat Jan 12, 2013 6:28 am, edited 1 time in total.
User avatar

By brandoff88
- Sat Nov 03, 2012 4:55 am #319110 ok EH2_andy, i think your diagram may have helped i got to looking at STOCK set ups and realized with a stock intake setup instead of the little filter on the valve cover you have the lines...

Image

the red in the image represents the lines i dont have, the green hose is what i believe to be the hose dangling right now, and the green circle is what i believe to be the nipple i have thats open, would that make sense? or am i wrong about that...i just dont see how i could get them to connect if i were correct. :?

EDIT: i will try tomorrow to get more detailed pic where the hose comes from but i belive this is the solution, i have to work from 9-6pm tomorrow so it may be dark before i get home...if you can take some pics of your set up with the simillar lines mentioned i can go from there, but what i found on google seemed to be pretty conclusive to this, unless im competely retarded...i hope i made that as clear as possible

thanks again for your time and advice :thumb:
Last edited by brandoff88 on Sat Nov 03, 2012 4:59 am, edited 1 time in total.
User avatar

By FG2_Andrew
- Sat Nov 03, 2012 4:59 am #319111 Is it the really short hose?
User avatar

By brandoff88
- Sun Nov 04, 2012 6:43 pm #319169 im a little confused by that question, is what the little short hose? i think the one thats dangling in my picture is the green hose, and the green circle is the nipple thats open in my picture, but it never came with the red colored parts(had sri on it wheni bought it) im going to look at it in a few minuets and try to snap some better picks where it comes from and what the hose is shaped like, thanks again for your help andy
User avatar

By familyEGuy23
- Sun Nov 04, 2012 9:29 pm #319172 I ran into similar problem they told me to just plug it
http://www.civic-eg.com/viewtopic.php?t=25385

Let me know if you do find location
User avatar

By brandoff88
- Sun Nov 04, 2012 11:17 pm #319179 so i finally figured out a few of my issues, throttle cable is still confusing me, but i found that the nipple and hose WERE connected, found the piece on my spare intake manifold, and just didnt use the top piece from the valve cover to intake tube...got alot more stuff done, pics will follow

the piece i used
Image
Image

so far whats done
Image
Image
Image

got most the wiring done, cept passenger side and dizzy/o2 sensor...all the hoses are hooked up right and ready to go, just gotta throw in the axles, fluids, and swap calipers. then its just finishing the rattle can paint job :thumb:
User avatar

By familyEGuy23
- Mon Nov 05, 2012 10:10 am #319215 Looks good :thumb:
If you don't mind me asking where does that hoes go? (The one your holding onto in 2nd pic)
User avatar

By brandoff88
- Tue Nov 06, 2012 6:18 pm #319313 first of all thanks guys, and second i took a pic of where it comes from on my spare block

Image

and then you need this piece
Image

then that connects to here
Image

didnt think to look at STOCK setups lol, most modded hondas wont have them, i just got lucky when i bought my new motor it was on there lol. hope this helps
User avatar

By familyEGuy23
- Wed Nov 07, 2012 8:43 am #319398 thanks bro :woot: that was the only thing holding me back from getting my car on the road (engine wise):thumb:
User avatar

By brandoff88
- Thu Nov 08, 2012 5:58 pm #319515 hey guys, got a new o2 sensor in, everyone knows what that looks like and where it goes, unfortunatly no updates as of the last couple days, been working noon -9pm and i dont have days off till sun/mon, and it gets dark around 5 here...soo yeah...hopefully i can get everything ready this weekend, and then ijust have to go get my license, still wating for oregon to confirm damn sr22 policy..
User avatar

By familyEGuy23
- Mon Nov 12, 2012 1:53 am #319769 Hey bro sorry to jack your thread will be great if you can help me out with another question, in this pic my iacv is connected to that nipple

brandoff88 wrote:
Image


Where is your iacv hoses connected to?
 Reply
Return to Your Ride - Coupe