Post YOUR Hatchback here
User avatar
By Punksz6
#280830
User avatar
By bigJOE671
#282326 Here's an update, I got back from Cali on the 19th of November. Wanted to do something to my car but got a into a set back :( This is my first flat tire on my own car I ever changed.

The sidewall is broken


Another view


Put steeley on :)


looks like a drag racer ;)


When I was driving, not to mention I have no power steering, I busted a U-turn. I noticed that the steering wheel was pulling really hard in the other direction. So I decided to air up the tires. I Stopped at the nearest Wawa and put air into the tire. It filled up but when I took it out the air hose out, all I heard was a HISSING noise and the tire quickly deflated :( I quickly realized this tire is F!@#ed! This tire was the front passenger side. So I took off the back wheel and put the steeley on there. Then swapped the front with the back wheel. It took about 10 mins per each wheel. The only problem I ran into was that the jack couldn't fit under the jacking point in the front. I said "fuck it" i'm just gonna jack it up wherever it can go.

Now my car is waiting at a tire shop. I was gonna buy some stuff for my car but now it's going to a tire. I saw another hatch back there but didn't take a pic. Unfortunely where I'm located tires shop around here are not use to hearing 205/50 R15 tire size. Only one place here carried it.
User avatar
By dbrooks
#282334 That sucks about your tire! But it is a good time for brand new ones!
User avatar
By bigJOE671
#287000 So I got my tire but I have no pic of it.

I got a question...Where is a cheap place where I can buy a skunk2 shift knob? Besides Ebay.



Uploaded with
User avatar
By dbrooks
#287054 I looked for that shift knob, but I actually couldn't find one.

I did find one that looks pretty much the same though and it's OEM :thumb:

User avatar
By dbrooks
#287164 The Si's are lookin' good :thumb:
User avatar
By bigJOE671
#288623 Got these in the mail today. I had to put them on since I didn't do anything to my car in a while.


Before passenger side


Before front



Before driver side


Pulled both corner lights out. To pull them out. You have to open the hood, loosen the screw on the top part of the corner light, pull the corner light out towards the front of the car, disconnect the light bulb, then now you can take the corner off.


Side by side comparison


After Passenger side


After front


After driver side


Ran into one problem when i tried installing the driver side corner light. The hole for the screw didn't line up :x Its off by 1/4 inch. so i just didn't put a screw. I tried to force to line up but no luck :(


Uploaded with