Page 1 of 1

ok b16a help please

PostPosted: Sun Apr 06, 2008 7:47 pm
by {EG} JAY Ride or get rode
i finished putting the head and tranny and everything off my b17 motor two weeks ago it ran fine all last week until bout thursday or friday now my motor makes a weird noise not a rod knock noise though and it has no power and i can drive it to 4 thousand rpm then it loses power so i have to shift it will also make a weird noise and i will drive in fifth and it loses all power like wont wanna go so i down shift and then it kinda goes but makes a weird noise and now it will start but i have to keep the gas pushed all the way to the floor and keep pumping it while i turn the key anyhelp or suggestions???

Re: ok b16a help please

PostPosted: Mon Apr 07, 2008 12:12 am
by IdealPerformanceIndy
{EG} JAY Ride or get rode wrote:I finished putting the head and tranny and everything off of my b17 engine two weeks ago. It ran well last week until about Thursday or Friday. Now, my engine makes a weird noise (not a rod knock noise) and has no power. Interestingly, I can rev it to 4 thousand rpm and before it loses power, forcing an upshift. When I am cruising in fifth gear it will occasionally lose power, in this case forcing a downshift. At present it will start, though it requires the full throttle opening and intermittent pumping of the pedal while I turn the key. Can anyone offer any help or suggestions?


Fixed.

PostPosted: Tue Apr 08, 2008 10:33 pm
by {EG} JAY Ride or get rode
found out what was wrong the cam gear slipped and fucked up where the key sits on the cam so i am looking and think i found a new one

PostPosted: Wed Apr 09, 2008 5:11 am
by chrono404
Awesome, Let us know if that fixes everything :thumb:

PostPosted: Wed Apr 09, 2008 5:37 am
by {EG} JAY Ride or get rode
will do i found a set of gsr cams so i might be getting those