Page 1 of 1
b18c1 question
Posted:
Thu Feb 21, 2008 1:09 amby hondalowlow
when i rebuilt and swapped my gsr in my eg coupe, the knock sensor broke when i removed the clip and took off the harness. some people tell me that i dont need a knock sensor for obd1 some people tell me i do.
obd1 b18c1 in a obd1 eg 92-95 civic. p72 ecu.
please let me know. because if i dont need one i wont spend a shit load of $ that i dont need to.
Posted:
Thu Feb 21, 2008 1:41 amby chrono404
You can have your ECU Chipped to not need a Knock Sensor.
However Honda did spend a good chunk of money to put a knock Sensor on all Vtec B-Blocks. I am sure they put it in there for a Reason.
Posted:
Sat Feb 23, 2008 4:44 amby hondalowlow
yes good point. anyone got one lying around>
Posted:
Sat Feb 23, 2008 5:50 amby Greasedmonkey
Im sure you can find one at your local junk yard.
Posted:
Thu Mar 13, 2008 7:38 pmby miguel329
if using aftermarket pistons u dont need it.. i had mine removed
Posted:
Sat Mar 29, 2008 10:46 pmby id3379
just have your ecu chipped, you'll be alright.
hit up katman
http://ecu.ff-squad.com/
Posted:
Sun Mar 30, 2008 2:50 amby MrLayLo
well well well... chipped p28 is the way to go. plus if you bring ti to a programmer, they can chip it to the specs.. with what you have done and how you wanna run the engine. remember... only USDM vtec motors came with them for emissions purposes only... JDm motors dont have knock sensors... which means... to hell with it!