pinched coolant hose

B16, B18, B20
 Reply
User avatar

pinched coolant hose

By Josiah
- Tue Oct 14, 2008 3:10 am #74216 i put a b18 in and now i have a 1inch hose that goes into the firewall from the motor that is pinched, it doesnt fit right, its coolant, my question is does it matter? would a hose fit from a b18? what is the hose going to called? heater? thanx in advance. vtec now wired to ecu!! YAY YAY!
User avatar

By Classiccarsrule85
- Tue Oct 14, 2008 12:21 pm #74248 well which one is it the one on the bottom or top? since i think the one from the top you can use a b18's or in worst case scenario undo the hose and measure by laying it in place and making some adjustments i.e. cut the thing to fit....

By sdots
- Tue Oct 14, 2008 2:15 pm #74261 You can use one off a B18 as most of them are a generic size as far as I know of.
It will either be the inbound or outbound heater core hose which circulates coolant through it.
User avatar

By Josiah
- Tue Oct 14, 2008 8:12 pm #74308 i will order the bseries hoses, but does it matter if its pinched, looking at the firewall its the one on the right.
User avatar

By Josiah
- Sat Oct 18, 2008 2:45 am #74764 what does that go to? im dying from fumes

By sdots
- Sat Oct 18, 2008 10:18 pm #74920 right on mine, which is a right hand drive vehicle is the inlet, it should have a plastic black looking valve on there which controls hot coolant entering the system. i'll try getting you a pic of mine so you know where the hoses connect up to
 Reply
Return to B Series