Page 1 of 2

Oil leak!!!

PostPosted: Thu Aug 06, 2009 10:52 am
by Simmons
Where does this oil come from?
What must i fix?
Image
Image
:cry:

PostPosted: Thu Aug 06, 2009 1:21 pm
by teal_dx
looks to be a leaking head gasket

PostPosted: Thu Aug 06, 2009 1:36 pm
by Simmons
Thanks TEAL :thumb:

PostPosted: Thu Aug 06, 2009 1:46 pm
by ChicagoMike
Actually I'm gonna disagree. Looks like there's oil from above the headgasket. Check the distributer, and stuff up that way. But its kinda hard to tell from the pics, they're pretty small.

PostPosted: Thu Aug 06, 2009 2:10 pm
by Simmons
Image
Image

PostPosted: Thu Aug 06, 2009 2:15 pm
by ChicagoMike
I'm standing by something other than the headgasket. :thumb:

PostPosted: Thu Aug 06, 2009 2:22 pm
by Simmons
Ok thanks guys

PostPosted: Thu Aug 06, 2009 2:37 pm
by teal_dx
if that's an old leak, then I say HG. Oil will slowly seep its way up over time as dirt and dust sticks to it. And there's a lot below as well.
There is an O ring on the distributor shaft that can leak but look how clean the tranny is.

There are some sensors on the side of the head under the distributor... you might check if one of those are leaking but I don't think any of those are oil related...

PostPosted: Thu Aug 06, 2009 3:18 pm
by Punksz6
It looks like its coming from the dizzy I agree with Mike and Teal..U could always wipe or look right under the dizzy to see if its leaking...

PostPosted: Thu Aug 06, 2009 6:39 pm
by dawg316
simple green it and see if the leak comes back :thumb:

I also think it could be from the distributor. go check it out

PostPosted: Thu Aug 06, 2009 9:23 pm
by Greasedmonkey
I'm going with dizzy o ring.

PostPosted: Thu Aug 06, 2009 9:28 pm
by egsedanguy
dawg316 wrote:simple green it and see if the leak comes back :thumb:

I also think it could be from the distributor. go check it out


yup totally..

PostPosted: Thu Aug 06, 2009 11:35 pm
by Ajax1989
it could be the HG and VC gasket as well

but my car is doin the same thing
but its my o ring inside the dizzy not the one
outside the dizzy

so ima sa the O ring

PostPosted: Sat Aug 08, 2009 5:55 pm
by Eg6H2D
mINES DID THAT BCUZ OF THE VALVE COVER GASKET. ON A Z6. ONE OF THE BOLTS TO HOLD THE VALVE COVER WERE STRIPPED SO NOT MUCH HOLDING DOWN POWER THERE. SOOOOOOOOO IM LOOKIN AND TO BE THE O-RING OF THE DIZZY SEEMS A BIT FAR. SO DO THIS..

CLEAN THE AREA .. GOOD. ..

TURN ENGINE ON. AND REV FROM THE ENGINE BAY. DONT REDLINE THE ENGINE, JUST GIVE IT SOME STEADY REVVIN AND WATCH.. SEE WHERE IT'S COMING FROM. LOOKS LIKE A HEAD GASKET, BUT U WOULD SEE OIL AND COOLANT MIX RIGHT TEAL?...

PostPosted: Sat Aug 08, 2009 5:59 pm
by ChicagoMike
^^^Stop yelling!!^^^ :x