Civic-EG.com Forum 3.3.1

- Tue May 18, 2010 4:46 pm #195061 so a Friend of mine called me this morning and told me one of his buddies is selling a greddy turbo kit for 500 obo has everything but a manifold i dont know much about turbos but i wanna make my stock D16z6 faster i was doing some research and found out that greddy bolt on turbos are meant for stock motors which is what i have. how do i check if the turbo is any good so i dont get robbed for my money and what parts should i look for in the sale

I'm going to the gulf, swim down and plug that oil leak with my dick

- Tue May 18, 2010 6:14 pm #195076 Greddy's turbo kits are pretty good from what I hear. Look at the turbine and see if theres any chips/goudges in it, check for shaft play, see if theres any cracks or anything on it...

R.I.P. Coty "CoCo" Swanson
7-9-91 to 8-16-09
Free Gabe Lorenz!

- Thu May 20, 2010 2:14 am #195540 What he means by shaft play is any movement in the shaft other than it spinning; i.e. side to side, up and down, in and out.

Also make sure you have all of the following:
- Turbo
- Intercooler
- Intercooler piping
- T-bolt clamps
- Couplers
- Blow-off valve
- Wastegate
- Dump pipe
- Fuel injectors
- Resistor box (if the fuel injectors are low impedance)
- Boost gauge
- Vacuum lines
- Vacuum Ts or a Vacuum manifold
- Oil feed line
- Oil Drain line
- Drain line fitting for your oil pan
- T splitter for your oil feed line
- Downpipe
- Gaskets and bolts for everything

- Fri May 21, 2010 3:08 am #195824 Yummy! That sounds like a hell of a deal!

- Tue Jun 15, 2010 2:17 am #200434 Sounds dece.

The GReddy TD04H has a T25 inlet flange, so just buy yourself an ebay cast manifold with a T25 flange.

Shitruiners Inc.