- Wed Sep 23, 2009 5:33 am
#146216
Would I need to do any mods to the front bumper in my 92 lx to install the turbo intercooler??
Chance is a homo # 69
- Wed Sep 23, 2009 5:53 am
#146237
depends on size really. most likely yeas cut out the mesh in the grill
Chance is a homo # 69
Chance is a homo # 69
- Wed Sep 23, 2009 1:30 pm
#146320
sometimes you can get away with just trimming the back side of the bumper so it will appear stock. I was able to do this on mine but it was a tight fit!
ps. changed your title to something useful. "Help please" is not very helpful
ps. changed your title to something useful. "Help please" is not very helpful
Do Not PM me your technical questions. Post them in the forum! 
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage
- Wed Oct 07, 2009 4:07 am
#149227
Yup, I had to do minimal trimming to mine. It takes three hands to get it on since it's tight (I just use my knee and one hand to hold it in place, and my other hand to screw it in
) but it looks waaaay better than those guys that cut out the entire center bit and all you see is an intercooler.
Shitruiners Inc.
teal_dx wrote:sometimes you can get away with just trimming the back side of the bumper so it will appear stock. I was able to do this on mine but it was a tight fit!
ps. changed your title to something useful. "Help please" is not very helpful
Yup, I had to do minimal trimming to mine. It takes three hands to get it on since it's tight (I just use my knee and one hand to hold it in place, and my other hand to screw it in
) but it looks waaaay better than those guys that cut out the entire center bit and all you see is an intercooler.
Shitruiners Inc.