Door car materials splitting
Posted: Mon May 18, 2015 6:20 pmMay be awnsered on here but not looking haha does anyone know if the material splits from the doorcar plastic without breaking it cheers its a EG hatchback 93
Civic EG
Forum for the Honda Civic EG 1992-1995
https://forum.civic-eg.com/
Door car materials splitting
Page 1 of 1
Posted: Mon May 18, 2015 6:20 pmPosted: Tue May 19, 2015 10:23 pmwell the vinyl will separate from the panels. but its a bitch. I did it once to re-wrap them. as for the insert of the panel you have to take it off from behind. there is melted rivet spots that have to be removed with like a grinder or even a sander with 40 grit could work. the material will come off there really easy. hope this helps
Posted: Wed May 20, 2015 3:13 amthe fabric on mine was already falling off. so needless to say i just peeled it right off in 2 seconds
but like egsedanguy said, they are like melted into the rest of the door panel. i used a die grinder but that chewed them up pretty bad and made reistalling them a pain in the ass.
but like egsedanguy said, they are like melted into the rest of the door panel. i used a die grinder but that chewed them up pretty bad and made reistalling them a pain in the ass.
Posted: Wed May 20, 2015 1:20 pmAh okay whats the bsmest way to attach the two back together after trimming it? Cheers
Posted: Wed May 20, 2015 10:25 pmHaydonnn wrote:Ah okay whats the bsmest way to attach the two back together after trimming it? Cheers
when attaching them back there is a few ways. 1 way is to glue them back on at the original spot with a fast epoxy/glue.
the other way is to get some short screws with a washer and screw it back in the original spots. just be sure they are short or you will go threw. I liked this method a little better since I could take the screws out mush easer if I wanted to change up the material.
Posted: Wed May 20, 2015 10:32 pmhttp://i54.photobucket.com/albums/g115/ ... ed/010.jpg
http://civic-eg.com/causeforalarm/actua ... _panel.jpg
http://i54.photobucket.com/albums/g115/ ... ed/019.jpg
here is some pics. the bottom one is the panel removed and you can see all the holes. that where it is bonded to the rest of the panel
http://i54.photobucket.com/albums/g115/ ... ed/027.jpg
this shows how the screw method works.
hope this helps.
http://civic-eg.com/causeforalarm/actua ... _panel.jpg
http://i54.photobucket.com/albums/g115/ ... ed/019.jpg
here is some pics. the bottom one is the panel removed and you can see all the holes. that where it is bonded to the rest of the panel
http://i54.photobucket.com/albums/g115/ ... ed/027.jpg
this shows how the screw method works.
hope this helps.
Posted: Thu May 21, 2015 3:21 ami used the screw and washer method it was super simple
Posted: Thu May 21, 2015 6:29 amOkay cool cheers il try post a pic up once iv got the alcantara on it and back together haha cheers people!
Posted: Sat May 23, 2015 7:43 pmIt's plastic welded. You can buy the tool on Amazon pretty cheap and it's a lot better than rigging it with some random hardware.