Civic EG

will ITR pistons fit in a jdm B18B?

They will fit, but you will have to modify teh LS rods to fit the pistons. I believe they need to be milled down 1mm on each side to fit the piston.

Yes they'll fit, but you're gonna have crazy high compression, plus you have to do some work to the LS rods to get them to work.

What kind of gas do you plan on using, also what are you gonna be using to tune with??

You could just use B16 pistons if you're gonna do a basic build. No rod modification, and you'd be fine on pump gas.

with the US ITR you get a 11.2:1 CR And with the JDM ITR pistons you get arround a 11.7:1.

With teh PR3s from a US b16a you get 11.37:1 and with the P30s from the JDM b16a you get a 11.6:1.

All of those are pump gas friendly.

will I need to do work to the LS head 4 that much compression I got Eagle rods 2 and tha y are for a type R

Those Eagle rods for the Type R are a no go. Dont use them. They are too long. the stroke from a GSR/ITR is different than a LS or B18b

what ones do I get? B16 or what I dont want to mill the rods

then you get either the JDM or USDM B16a pistons. And you use your stock rods.

but the stock rods are no good so do I get Eagle rods for a b18b would that be good

rods for the B18b would work.

ok cool

will GSR rods be good?????????????????????????????

NO. They are the same as ITR rods.

JDM FERIO MAN wrote:will GSR rods be good?????????????????????????????

Greasedmonkey wrote:Those Eagle rods for the Type R are a no go. Dont use them. They are too long. the stroke from a GSR/ITR is different than a LS or B18b

If you ask a question, please read the given answers ;)