Civic EG

Hi people, I recently purchased a set of Rota Zero Plus's. Loving the wheels but the offset is ET10.

My question is, would it be possible to take the wheels somewhere and shave about 5mm off the offset so the wheels tuck in the arches without scraping? I think that's all I need to shave off, I've set a bit of camber too which helps but not too much otherwise my tires will die.

I don't fancy rolling the arches. I've also heard that by shaving the offset off of a wheel weakens the wheel, but would 5mm be ok?

Or shall I just sell them and get another deep dish wheel with an offset that will fit better?

Thanks,
Paul

Dont mess wit the wheels. Roll/pull your fenders to fit the wheels if you must use them.

New wheels it is then.