Civic EG

Got a 93 Civic Si.

I want to do a front teg conversion of my brakes. Any one know what's needed? I know 92-93 civic Si/Ex No ABS.
and 94-95 Civic Si/Ex has ABS .

does that mean i have to get all Non ABS Parts? it's obvious yes. but im still wondering.

which TEG from 94-95 is non ABS?

is it the RS?. Can i use those.

ABS/NON ABS will work
you can use NON ABS or you can use ABS parts. it wouldnt matter.
92-95 civic EX/Si
and all 94-01 integras will work.

ok great. so i need rotors, caliper, pads. and caliper bracket?

anyhting else?

Ok pretty much get the whole front spindle from a integra, which would include the arm,wheel bearing,calipers,rotors,pads etc....

your will need a integra brake line as the EG lines are a bit short compared to eh integra ones.....

I did a GSR brake upgrade on my hatch
comparison to my cx hatch


GSR brakes


Thats pretty much all that you need up there in the second picture

hmmmm ok. ill see what i can find..

ok now isn't the knuckle / spindle the same size as i have now. just the integras have a bigger rotor and caliper?

i know in these EG civics the DX/Cx ones are smaller then mines. ive read before jus cant remember where. then some civic Ex/Si's have the 10in rotors. i believe those are the ones equipped with ABS.

what's the size of teg rotors? RS-GSR tegs?

ii can get an awesome deal on new calipers/rotors/ brackets and pads. i just dont want to go and get some used front parts like pictured above. then later my wheel bearing/hub or caliper goes and need a new one. lol. the ones i have now are good.

lol im just a lil itchy when it comes to getting used things..