Page 1 of 1

Engine Chassis Grounds?

PostPosted: Tue Apr 10, 2007 1:53 pm
by teal_dx
I forgot to make a list of the engine chassis grounds before I took everything out... Now I'm sure I'm forgetting one :?

1. Valve Cover
2. Thermostat
3. Transmission

Was there one on the starter too? any others?

PostPosted: Tue Apr 10, 2007 2:07 pm
by vtec_gloucester
ive only ever know of 2. lol

on the cam cover and gearbox.

PostPosted: Tue Apr 10, 2007 4:11 pm
by asianrob
the one for the start is on the wiring harness that should be about it other than that

Re: Engine Chassis Grounds?

PostPosted: Sun Jul 22, 2007 4:22 pm
by sTArviN
teal_dx wrote:I forgot to make a list of the engine chassis grounds before I took everything out... Now I'm sure I'm forgetting one :?

1. Valve Cover
2. Thermostat
3. Transmission

Was there one on the starter too? any others?


i had mine installed with 6 grounding points...

valve cover
transmission
distributor
alternator
throttle body (intake manifold)
body
(headlight alternative)

Re: Engine Chassis Grounds?

PostPosted: Sun Jul 22, 2007 5:09 pm
by projecthonda
sTArviN wrote:
teal_dx wrote:I forgot to make a list of the engine chassis grounds before I took everything out... Now I'm sure I'm forgetting one :?

1. Valve Cover
2. Thermostat
3. Transmission

Was there one on the starter too? any others?


i had mine installed with 6 grounding points...

valve cover
transmission
distributor
alternator
throttle body (intake manifold)
body
(headlight alternative)
i have this kind of setup :thumb: using a grounding kit :)

PostPosted: Sun Jul 22, 2007 7:23 pm
by stefan
I only have two groundwires, the thin one on the valvecover and the thicker one on the bracket at the gearbox...

Recently renewed both, just used some audio cable I had laying around (25mm? @ gearbox / 16mm? @ valvecover), kept them as short as possible and made the end pieces of wire solid with tin, and soldered the ends into cable shoes, perfect contact :)

Runs a bit smoother it seems, no increase in light brightness or fuel economy etc.

PostPosted: Sun Jul 22, 2007 9:22 pm
by Sire
I think the starter is supposed to have a ground too....

PostPosted: Sun Jul 22, 2007 10:31 pm
by stefan
Doesn't the starter get its ground from the engine itself?

All I have is a big 12v+ cable to it, and a smaller one (on/off signal?), and it works perfectly :)

ground points

PostPosted: Fri Mar 21, 2008 3:32 am
by civic93
i just bought a grounding kit for my eg. its seems that i can diy it. i understand that all these wires from these grounding points should be connected to the negative pole on the battery right?

how about the oem ground wire to the body from the engine for example, do i just replace it with the new ground wire or reroute it to the negative pole as well?

any suggestions where the good grounding points are?

thanks a bunch