Civic EG

on my vx im doin a healight tuck.on hte drivers side theres the headlight plug,the turning signal,the ground box thingy and 2 other clips that im unsure of.(annyone know)
can i remove the other 2 clips and just run the headlight plug and corner buld and combone those 2 grounds for lack of a headache??????

I would just keep the whole clip intact and run it to a ground with a wire. The time you spend taking it apart is more than it would take to ground it as is. You're relocating it to the inside of your fender right? so nobody will see the big ugly plastic clip.

i understand that but im not sure what teh other clips are for?if i do the tuck and throw the motor in and im 2 clips short im fucked.i know there is the mc sencor wires that go to the cap of the mc,jthen there are the lights (cornerand healight).so what the fuck are the other 3 clips for.
i didnt have cruise.i know the washer fluid one if gone forsure.im kinda lost anyone got a pic of a stock harness with the clips marked.it would help alot

When I did mine I didn't have much of a clue what some bits were so held off on the wires for a bit and put the motor in then went back once everything was plugged in and tucked the rest away then you know everything is in the new right place.

I misunderstood your question before.

I kept everything, didn't want to risk remove something I would end up needing.
So, I'm not sure. If you have a haynes manual, check in the wiring diagram section.