Civic EG

Can someone show me on the block, where my oil pressure switch is? thanks in advance

What motor??

My bad, B16a

look on the back, toward the top edge, Above the oil filter. it has 1 wire going to it.

i thought that was for the vtec, i need the one that sends the pressure from the block to the ecu.

what I'm needing it for is to hook up my oil pressure guage. Or if some one knows of a diagram that is labeled what ecu pins are what I may can pick it up from there

fastfiveo2 wrote:i thought that was for the vtec, i need the one that sends the pressure from the block to the ecu.

That is it, it's not for VTEC.

The only thing I can find on the back of the block is my knock sensor and my oil filter, nothing else what so ever.

fastfiveo2 wrote:i thought that was for the vtec, i need the one that sends the pressure from the block to the ecu.

here's the one on the head for vtec:


Here is the one on the block:

this one has a T adaptor on it, but you can see where it is located. to the right of the alt and left of the oil filter, then a little up.

Thank you so much, now the problem is i have to put a fitting and a T in it so my sending unit for my guage will fit. Anyone know what thread size i need to fit in the block?

aftermarket oil pressure senders are huge..

http://www.stealthmodeperformance.com/o ... wall.shtml

use this to relocate it.

http://www.theoldone.com/articles/oilpressure/

or get an oil sandwich plate adaptor:

teal_dx wrote:or get an oil sandwich plate adaptor:

holy crap! it fits. I actually running a sandwich adapter and a line to under the brake master cylinder area where i mounted my oil pressure sender.

It was kind of a PITA to install, and I'm usually pretty good at working in tiny spaces.

Thank ya'll so much, you've been a huge help. I think I have it all worked out now just have to put it all in. Thanks again.