Civic EG

i got bored saturday so i tucked the connecters up on the drivers side corner. not very detailed but you get the idea. i had already tucked the side wires on both pass and driv so i decided to finish one side completely

here is the finished look


soldering and heat shrink tubing




inside the car now is these connectors

the finished look underneath the fender


what i had to extend for the inside connectors

here are the sides that i tucked that i was talking about. (along the body)

its commin along man lookin good

already looks better white bays look so much cleaner without those harnesses running along the sides.

Be sure to insulate the wires from the edges of the holes in the body before you put it back together & start driving. They can wear through eventually & short out.

teal_dx wrote:already looks better white bays look so much cleaner without those harnesses running along the sides.

I cant wait.


-EJ1- COUPE, its looking good man! Did you soldier the connections or did you just use butt connectors?

york 62 :its alll soldered

teal: i used wire loom around the parts that came across edges and then wrapped in electrical tape

o those arent butt connectors thats heat shrink lol

-EJ1- COUPE wrote:o those arent butt connectors thats heat shrink lol

haha, ya i never noticed that the pic can blow up, now i see that its srink wrap, just at first glance i thought it was the red butt connectors. my bad

its all good. this weekend i might do the fuse box relocation but not the battery. i want to mount the box in the bottom of the blower motor ive seen it done and its clean. youve got to love free mods

good time to re-route your hood cable while you have your fender off

i should do that to i also have to cut my sidemarkers in as well thats what those other wires are hanging in my fender. where was the thread about the cable ?

http://www.civic-eg.com/viewtopic.php?t=112

sweet deal thanks teal woh that rymed