Civic EG

Posted: **Thu Jul 26, 2007 9:37 pm**

hey fitzy ill look into it more for you buddy

Posted: **Thu Jul 26, 2007 11:04 pm**

what pins on the plug are the wires in?

edit: this might help:

http://civic-eg.com/pics/ecu/ECU_pinout_obd1_2.jpg

Also I'm gonna move this thread to the electrical section :thumb:

Posted: **Thu Jul 26, 2007 11:58 pm**

thanks for the help teal thats one of my good buddies he just got a eg hatch with a y8 and weve been haven trouble with it

Posted: **Fri Jul 27, 2007 1:18 am**

cool, lets figure it out :thumb:

Posted: **Fri Jul 27, 2007 4:48 am**

no MAP will cause it to run bad.

yeah you need an IAT, you can do this:

or just drill a hole in your intake tube and put it in there.

Posted: **Sun Jul 29, 2007 7:18 pm**

what year/engine harness do you have? I just looked at my map sensor and the wires are green/blue, yellow/green, white

you're using a P28 right?

Posted: **Mon Jul 30, 2007 1:40 am**

built-EGy8 wrote:Ive got my MAP all ready to be pinned but I have a little problem. There are 3 wires comming off of my MAP sensor. GRN/WHT,YLW/RED,andSolid WHT. which is pinned where in my harness?

Ok got it...

Green/White wire from the MAP sensor should change to Green/Blue after the main harness plug, and then goes to pin C11 on the P28

Yellow/Red wire from the MAP sensor should change to Yellow/Green after the main harness plug, and then goes to pin C10 on the P28

Solid White wire from the MAP sensor should change to Pink/White (93-95) or White (92) after the main harness plug, and then goes to pin C9 on the P28

Civic EG

wiring troubles

Re: wiring troubles