Page 1 of 1
running wires into passenger cab...
Posted:
Mon Sep 07, 2009 10:05 pmby stockd15
Im trying to finish wiring up my foglights. I wired it up before i finalized everything and they work. I bolted the foglights to the bumper and put the bumper back on the car. I just have to run the wires inside the car to the switch. The problem is i cant find a hole/plug to run the wires into the cab. I looked inside and out and didnt see anything. This is on the drivers side, does anyone know of one? This is on my 92 si hatch. I've searched and come up empty. This is all i need to finish the job!
Posted:
Mon Sep 07, 2009 10:27 pmby nig90
there is a spot next to the throttle cable on the left. thats where i had mine.
Posted:
Tue Sep 08, 2009 12:34 amby stockd15
thanks nig90 i'll check it out tomorrow
Posted:
Wed Sep 09, 2009 10:00 pmby nig90
heres a pic for you. i had mine running through that hole. then right up to my switch.
Posted:
Thu Sep 10, 2009 2:58 pmby BLaCkSiLo
i ran mine through a spot by the blower motor on the passenger side of the firewall
along with all my amp wires and stuff
Posted:
Thu Sep 10, 2009 5:37 pmby asianrob
if you move the fuse box in the engine bay theres a hole in the side wall you can fish it through there and run it inside the cabin too or theres one under the battery tray i think? (ill have to look at mine again thats where i got my power wire running through)
Posted:
Thu Sep 10, 2009 10:37 pmby Ajax1989
BLaCkSiLo wrote:i ran mine through a spot by the blower motor on the passenger side of the firewall along with all my amp wires and stuff
thats where my amp wire is