Oil press switch

ECU, Wiring, Sensors
 Reply

Oil press switch

By fastfiveo2
- Fri Jan 18, 2008 9:35 pm #38228 Can someone show me on the block, where my oil pressure switch is? thanks in advance
User avatar

By ChicagoMike
- Fri Jan 18, 2008 9:43 pm #38230 What motor??

By fastfiveo2
- Fri Jan 18, 2008 10:28 pm #38242 My bad, B16a

By fastfiveo2
- Fri Jan 18, 2008 11:57 pm #38255 i thought that was for the vtec, i need the one that sends the pressure from the block to the ecu.

By fastfiveo2
- Sat Jan 19, 2008 11:27 pm #38380 what I'm needing it for is to hook up my oil pressure guage. Or if some one knows of a diagram that is labeled what ecu pins are what I may can pick it up from there
User avatar

By JLau
- Sun Jan 20, 2008 1:15 am #38384
fastfiveo2 wrote:i thought that was for the vtec, i need the one that sends the pressure from the block to the ecu.


That is it, it's not for VTEC.

By fastfiveo2
- Fri Jan 25, 2008 2:55 pm #39294 The only thing I can find on the back of the block is my knock sensor and my oil filter, nothing else what so ever.
User avatar

By teal_dx
- Fri Jan 25, 2008 4:01 pm #39297
fastfiveo2 wrote:i thought that was for the vtec, i need the one that sends the pressure from the block to the ecu.


here's the one on the head for vtec:
Image

Here is the one on the block:
Image
this one has a T adaptor on it, but you can see where it is located. to the right of the alt and left of the oil filter, then a little up. :thumb:

By fastfiveo2
- Fri Jan 25, 2008 5:36 pm #39316 Thank you so much, now the problem is i have to put a fitting and a T in it so my sending unit for my guage will fit. Anyone know what thread size i need to fit in the block?
User avatar

By LowTEC-Derbo
- Fri Jan 25, 2008 6:26 pm #39328 aftermarket oil pressure senders are huge..

http://www.stealthmodeperformance.com/o ... wall.shtml

use this to relocate it.

http://www.theoldone.com/articles/oilpressure/
User avatar

By LowTEC-Derbo
- Fri Jan 25, 2008 9:11 pm #39342
teal_dx wrote:or get an oil sandwich plate adaptor:
Image



holy crap! it fits. I actually running a sandwich adapter and a line to under the brake master cylinder area where i mounted my oil pressure sender.

By fastfiveo2
- Fri Jan 25, 2008 11:49 pm #39357 Thank ya'll so much, you've been a huge help. I think I have it all worked out now just have to put it all in. Thanks again. :thumb: :thumb: :thumb:
 Reply
Return to Chassis - Electrical