h2b
Posted:
Sat Jan 30, 2010 1:42 amby i8umup
does anyone else on here have a h2b kit. im looking to borrow or get some specs on the block template used to grind off the rear of the block to make the driver side axle fit. i have the new swap ready to go in and dont have my template from the original block so....
Posted:
Sun Jan 31, 2010 2:43 amby dawg316
http://www.quartersportsdrag.com/Kit_Contents.html
and evolutions kit
http://www.honda-tech.com/showthread.php?t=2504490
if you just need to grind the block. why dont you just line everything up then grind it. i herd its just on the backside of the block to line a mount up.
Posted:
Sun Jan 31, 2010 3:09 amby mooze
on the back side so axle can clear. jut grind down the back side of block near the tranny until can get the axle in and turn it with your hand without it getting caught on anything
Posted:
Sun Jan 31, 2010 4:34 amby i8umup
yeah i know what and where the material needs to be removed but im just a little sceptical about doing it free hand and cuttin to deep then i got some f-ed up shit. i dont know though i called evolution industries they are gona send me one so they say should take about a week to get here any longer than that and i might just free hand it